Endure / Welsh Microscope

Assembly Page

	1. Remove tripod from case and set-up. Extend Base until the inner braces are horizontal. Tighten both knob and thumb screw on tripod.
	2. Insert articulating arm into the hollow end of the top joining sleeve of tripod stand.
	3. Loosen the knobs on the coupling at the end of the articulating arm until the hole in the coupling is unobstructed.
	4. Remove optical head from case. Remove securing knob from the head. Insert head post into coupling hole from the bottom and replace securing knob. Do Not Let Go Of The Head Until The Securing Knob Is Tight!
	5. Run the fiberoptic cable from the light source to the head. Secure the cable with a Velcro strap to the arm. If the Velcro is missing, a large rubber band will do the job.